Lexus · 2015–2022
NX 300h Recalls
4 known recalls affecting the Lexus NX 300h (2015–2022). Enter your VIN to check if your specific vehicle is affected, or browse by model year below.
Lexus NX 300h Recalls
Summary
Issue: Under certain conditions, the vehicle stability control (VSC) system may not switch on when the ignition is restarted. This can happen if the driver manually turns off the VSC, depresses the brake pedal, and then turns off and restarts the vehicle while continuously depressing the brake pedal. Canadian regulations require the stability control system to be active each time that you start the vehicle. Safety Risk: A stability control system that is switched off could increase the risk of a crash. Corrective Actions: The company will notify owners by mail and instruct you to take your vehicle to a dealer to update the skid control ECU software.
Summary
Issue: This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships. On certain vehicles, the engine block heater cable may not have enough heat protection and could be damaged by high temperatures. If this happens, the cable could short circuit while plugged in, and cause the wiring to overheat or melt. Note: This recall only affects the following block heater/cord part numbers: C014003034 PK5A408J09 PU14000904 C014003151 PK5A408J13 PU14000905 C014000885 PK5A489J11 PU14000907 C014000888 PK5A489J22 PU14000909 C014000907 PK5A410H00 PU14000911 C014100904 PU14000900 PU14000913 C014100907 PU14000901 PU14003571 C014100911 PU14000902 PK5A489J14 PK5A408J05 PU14000903 Safety Risk: Engine block heater wiring that overheats or melts could create the risk of a fire. Corrective Actions: Toyota recommends that you should stop using the engine block heater immediately. Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. For some vehicles, the corrective actions for this recall are under development. For others, a new engine block heater cannot be installed, and the owner will receive a refund of the purchase price of the engine block heater.
Summary
On certain vehicles, the airbag system pressure sensors and/or acceleration sensors used to detect vehicle impact may contain manufacturing defects. As a result, the airbag warning light may illuminate and the side/curtain shield airbags and/or front airbags may not deploy, increasing the risk of injury in the event of a crash. Correction: Dealers will inspect and replace the defective sensors as necessary. Note: This will not affect the front airbags of the Prius model.
Summary
On certain vehicles, the electrical power cords of some dealer installed block heaters may have been improperly manufactured, causing the wires to contact each other, resulting in a short circuit. A short circuit could lead to a fire which would increase the risk of injury and/or damage to property. Correction: For vehicles where the subject block heater was approved for installation, the dealer will replace the block heater assembly with a new one of an improved design. For vehicles where the subject block heater was not approved for installation, dealers will remove the block heater assembly. In the interim, until the remedy can be performed, dealers will cut the plug end from the block heater cord to disable the block heater's operation.
Related Recall Checks
Check recalls for specific Lexus NX 300h model years